Thingiverse
Minigun Keychain
by Freckles667
1
Downloads
4
Likes
0
Makes
As most of my things are, I did them because I was bored, so here you go, its very basic, and obviously I haven't painted it, but you easily can and make it look much better.
If you print it in the orientation that is in the thumbnail then you don't/shouldn't need supports.
BTW I might change a few things in the future, but IDK.
If you print it in the orientation that is in the thumbnail then you don't/shouldn't need supports.
BTW I might change a few things in the future, but IDK.
Freckles667 also publishes on
18 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
