Minima Karambit from Valorant

This is my first 3D print ever so be aware that this model is nowhere near perfect.This model comes in two parts: gray handle and yellow blade & pieces. The parts definitely do not fit together as well as I want them to so be prepared to use superglue, a cutting tool (I used pliers), and maybe even a file to grind down some of the pieces.To assemble the knife, the yellow blade is intended to fit into holes in the gray handle. However, I think supports are generated in these tiny holes so they're almost useless unless you can get those supports out. What I did was cut down the thin yellow stems of the blade to about 1cm and put superglue inside of the holes in the gray handle.I also superglued mostly everything else to ensure proper stability. The ring hole needs to be glued, as well as the tiny yellow light bars into their respective holes on the knife. There will be two longer yellow bars and one shorter one. The longer ones go on each side of the handle, and the short one goes to