Thingiverse
Minimal lamp
von sebastianrosca
144
Downloads
129
Likes
0
Makes
This is my view of a simple lamp that also adds a bit of color to everyday life.
It basically has 2 pieces, a top and a fin that needs to be printed 16 times.
From the lamp_top file you can observe that this has small slots for the blades to fit in snuggly.
I recommend using 1 or 2 shells and a maximum of 0.2 mm resolution. The infill here was 10 or 15% I don't remember.
Total print time : about 11 hours.
It basically has 2 pieces, a top and a fin that needs to be printed 16 times.
From the lamp_top file you can observe that this has small slots for the blades to fit in snuggly.
I recommend using 1 or 2 shells and a maximum of 0.2 mm resolution. The infill here was 10 or 15% I don't remember.
Total print time : about 11 hours.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
