Thingiverse
Minimal raspberry pi 3 mount with pin
door Hypnonotic
1
Downloads
0
Likes
0
Makes
This is a very simple remix that adds an m2 sized pin so there is no need for a screw and nut.
To use with a raspberry pi 3 B+ you will need to cut the top 11m of the model off to just above the pin hole in your slicer. This is to clear the added 4 pins on the B+ model.
To use with a raspberry pi 3 B+ you will need to cut the top 11m of the model off to just above the pin hole in your slicer. This is to clear the added 4 pins on the B+ model.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
