Thingiverse
Minimal Raspberry Pi 3A+ baseplate
por ncmreynolds
0
Descargas
0
Likes
0
Makes
This is an absolutely minimal plate for screwing a Raspberry Pi 3A+ to.
It is for when you want to fix one inside an enclosure with cable ties or a couple of bits of double-sided tape but not interested in decorative flourishes, lids etc.
The screw holes at the corners are only 2mm in diameter so quite a tight fit for the M2.5 screws used for the Pi. This is deliberate in case you want to use small self-tap screws instead. You can always ream the holes out a tiny bit to get an M2.5 started.
It is for when you want to fix one inside an enclosure with cable ties or a couple of bits of double-sided tape but not interested in decorative flourishes, lids etc.
The screw holes at the corners are only 2mm in diameter so quite a tight fit for the M2.5 screws used for the Pi. This is deliberate in case you want to use small self-tap screws instead. You can always ream the holes out a tiny bit to get an M2.5 started.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!