Minimal Tray Slider

This model is compatible with any trays that have a groove rail on the side. I use this PLA print to add a drawer under my desk. The hook goes into the groove at the edge of the tray, and I use two screws to attach it under my desk. The tail of the tray would drop a little bit if it is a long tray, as only a section of the tray is supported, but I am not putting anything heavy in the tray, and I am feeling lucky - I have been using this print for a month, and it is holding up strong. The tray/drawer will not fully pull out and stop when the hook hits the corner.p.s. The plastic tray is from the dollar store. Printing a tray would cost $5+ worth of filament, but buying one is $2.5.