Minimalist Key Holder

# Minimalist Key Holder

I've made a few key holders I've found on thingiverse and they always used sharp chamfers or the keys would poke out enough to stab me in the leg. I designed this to be as round, sleek, and minimal as possible.

Distance between two screws are 52.50mm meaning it can fit most keys that are 52mm from tip of key to edge of key hole. Longest example key is 56.40mm total length and 50mm from tip of key to edge of key hole. It can fit longer keys if they are canted sideways to not interfere with second screw but might poke out the side which defeats the purpose of the minimalist key holder. If requested, or I happen to acquire a longer key, I will make a new longer version.

Print settings don't matter much, I will update after I've used it for quite a while or if it breaks somewhere. Example photos were printed in PLA regular.

Print flat side on build plate.

Designed to use **2** **M3 screws** with or without **2** **M3 (5mm OD) lock washers** and **3*