Thingiverse
Minimalistic & smooth Corner Bracket
door MeisterEdel
855
Downloads
1.6k
Likes
0
Makes
Heyho
For a small project I did need some minimalistic brackets! Since I didn't particularly like most of the versions already available online, I quickly constructed a few myself and ended up installing this ones. After that Project I was asked to design a corner bracket in a similar way. So here it is!
Design Ideas
Round Corners
There are no hard edges to ensure a beautifully minimalist shape that no one can bump into unpleasantly :)
Hardware
Only 3 wood screws (contersunk as standard or flathead) are required for assembly. Two 4 mm ( x 20 mm +) screw to attach the angle and one 3 mm ( x 8 mm +) screw to attach the bracket.
Cap
I Added 2 Cap versions. One that can be printed standing upright and one that can be printed lying down. The upright one looks cleaner but eventually needs a brim. The lying one doesn't look that clean later on but is easier to print.
Scaling
You can scale the model up/ down if you like! But keep in mind that the Scr
For a small project I did need some minimalistic brackets! Since I didn't particularly like most of the versions already available online, I quickly constructed a few myself and ended up installing this ones. After that Project I was asked to design a corner bracket in a similar way. So here it is!
Design Ideas
Round Corners
There are no hard edges to ensure a beautifully minimalist shape that no one can bump into unpleasantly :)
Hardware
Only 3 wood screws (contersunk as standard or flathead) are required for assembly. Two 4 mm ( x 20 mm +) screw to attach the angle and one 3 mm ( x 8 mm +) screw to attach the bracket.
Cap
I Added 2 Cap versions. One that can be printed standing upright and one that can be printed lying down. The upright one looks cleaner but eventually needs a brim. The lying one doesn't look that clean later on but is easier to print.
Scaling
You can scale the model up/ down if you like! But keep in mind that the Scr
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
