Thingiverse
Household
Go to Model
Minimalistic spice rack (customizable)
1.1k
Downloads
925
Likes
4
Makes
Some presets have already been generated, but you can tune it at the customizer. To make it, you will need:
* Wooden sticks: found at any department or hardware store, the ones I used are 30cm of length and 2.5mm of radius. When customising the model, I set the radius to 2.65mm for a tight assembly. If you are not sure, print it with a smaller radius and open it a bit with the tip of a blade/scissors, it is easier than glueing loose sticks.
* Mounting tape: If you don't find a strong one like [this](https://amazon.com/Gorilla-Tough-Double-Mounting-Inches/dp/B00OXVG9FW?tag=n) or [this](https://www.amazon.es/Ceys-M99978-Bricocinta-tackceys-1-5/dp/B008OEDJSO?tag=n), you can customize the model to increase the mounting surface. You can test if it holds properly to the wall by sticking a stand full of spices close to the floor for a day.
It has been extensively tested: I printed ~10 different versions to ensure that the weight is properly distributed among the wooden sticks and can h
* Wooden sticks: found at any department or hardware store, the ones I used are 30cm of length and 2.5mm of radius. When customising the model, I set the radius to 2.65mm for a tight assembly. If you are not sure, print it with a smaller radius and open it a bit with the tip of a blade/scissors, it is easier than glueing loose sticks.
* Mounting tape: If you don't find a strong one like [this](https://amazon.com/Gorilla-Tough-Double-Mounting-Inches/dp/B00OXVG9FW?tag=n) or [this](https://www.amazon.es/Ceys-M99978-Bricocinta-tackceys-1-5/dp/B008OEDJSO?tag=n), you can customize the model to increase the mounting surface. You can test if it holds properly to the wall by sticking a stand full of spices close to the floor for a day.
It has been extensively tested: I printed ~10 different versions to ensure that the weight is properly distributed among the wooden sticks and can h
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
