Minimalistic Underdesk Cable Clamp

This is a simple Cable Clamp that can be screwed (e.g. Ø3x12 screws) or glued to the underside of your desk. It supports multiple cables at once and is printed in only a few minutes. Print preparation:Make sure that your print bed is clean and grease-free and use a quality brand and dry filament. Print settings:Use a 0.4mm nozzle with 0.2mm layer standard settings. Set the layer height to 0.24mm to save time. In this case speed is more important than quality. Boost MeLike it? Boost it! If you want to support me you can leave a tip at ko-fi.com/blecheimer.Disclaimer:This work by blecheimer is licensed under CC BY-NC-SA 4.0. The shown model must not be used commercially.Copying this model to other 3D printing websites is not allowed without my permission.