Thingiverse
Minimax MM16 table insert
door hawkdl2
0
Downloads
1
Likes
0
Makes
The insert on my 2005 Minimax MM16 table saw was a bit warped and needed to be replaced. I designed this replacement in Tinkercad.
There are two versions top choose from: “MiniMax - 16 Insert Square” and; “MiniMax Insert 8 Deg Back”. The hole in the casting where this insert sits on my MM16 is far from square. The back wall of the casting slanted in towards the bottom by 8 degrees. That makes a square insert like the original insert not fit properly. I solved this with the original insert by bending the screws. To better correct the problem, I engineered the insert to have a similar 8 degree slant on the back end. This version fits my BS perfectly.
Check to see if your casting is square or has a slanted face in the back and use whichever version is more appropriate for your BS. The “MiniMax - 16 Insert Square” version is the direct replacement for the original MiniMax insert.
I printed these on my Bambu P1S with eSUN PLA using the Bambu PLA profile. These will print fi
There are two versions top choose from: “MiniMax - 16 Insert Square” and; “MiniMax Insert 8 Deg Back”. The hole in the casting where this insert sits on my MM16 is far from square. The back wall of the casting slanted in towards the bottom by 8 degrees. That makes a square insert like the original insert not fit properly. I solved this with the original insert by bending the screws. To better correct the problem, I engineered the insert to have a similar 8 degree slant on the back end. This version fits my BS perfectly.
Check to see if your casting is square or has a slanted face in the back and use whichever version is more appropriate for your BS. The “MiniMax - 16 Insert Square” version is the direct replacement for the original MiniMax insert.
I printed these on my Bambu P1S with eSUN PLA using the Bambu PLA profile. These will print fi
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
