Minimized Cable Winder [3 Sizes]

VERSION 2.0 OF THIS MODEL IS AVAILABLE ON MAKERWORLD A simplified cable organizer that uses less material and prints faster.Print Settings:Print a pin. Place the flat side on the build plate, not the prongs. Use at least 3 walls. Infill is not required but will improve the quality of bridges.Use the 3mm gap pin for small/normal cables. Use the 5mm pin for larger cables. Either pin will work in all bodies.Print a body. Place the body on its side, open side flat on the build plate. Use at least three walls. No infill is required.Use the 50mm body for short cables.Use the 75mm body for average cables.Use the 100mm body for long cables.(Optional) Print a key. You can insert the key into the gap of the pin to help you wind your cable.The normal size (75mm) should take around 12g of filament.Remember to LIKE🧡 the model and FOLLOW!