Thingiverse
MiniNES
par harrysachz
61
Téléchargements
43
Likes
0
Makes
MiniNES updated for the Raspberry Pi v2 / B model. Let me know what you think! This was a great learning experience.
Known Issues:
- Posts should be larger for stability. (Used #2 @ 1/4")
- Needs hole for Micro-USB. (Dremeled hole to fit)
- Hole in back for power cable isn't used.
- Lid needs to be slightly wider to fit properly.
Ideas for next v2:
- Get Pi into a better position to cut down on cable clutter. There is a lot of extra room inside the case that can be put to use.
- Put a USB extension to the front of the case where controller would be on original NES.
- Fiber optic routed to where Power Led would be on original NES.
- Get buttons to be functional.
- Get a better 3d printer. The one I used annoyingly warps things.
Tips for others:
- Download RetroPie for Raspberry Pi - http://goo.gl/kxyQmO
- Copy image to MicroSD card - http://goo.gl/1vAUij
- Follow these installation instructions - http://goo.gl/oEE4O1
- How to setup XBOX
Known Issues:
- Posts should be larger for stability. (Used #2 @ 1/4")
- Needs hole for Micro-USB. (Dremeled hole to fit)
- Hole in back for power cable isn't used.
- Lid needs to be slightly wider to fit properly.
Ideas for next v2:
- Get Pi into a better position to cut down on cable clutter. There is a lot of extra room inside the case that can be put to use.
- Put a USB extension to the front of the case where controller would be on original NES.
- Fiber optic routed to where Power Led would be on original NES.
- Get buttons to be functional.
- Get a better 3d printer. The one I used annoyingly warps things.
Tips for others:
- Download RetroPie for Raspberry Pi - http://goo.gl/kxyQmO
- Copy image to MicroSD card - http://goo.gl/1vAUij
- Follow these installation instructions - http://goo.gl/oEE4O1
- How to setup XBOX
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
