Slicer Discord
MiniPizza cutter – 3D-printbaar model van Thingiverse Thingiverse

MiniPizza cutter

door screet
78 Downloads
82 Likes
0 Makes
Model downloaden
If you like to make your own pizzas, like i do this is must have! Normally i make whole oven plate full of pizza dough but since we have party coming and lot's of people i desided to make mini-pizzas. Ofc it's lot of work but still it does not that much longer.

Worked fine for 2-3mm dough. Outer ring cuts and the middle ring presses round to prevent the tomato sauce spreading all around and gives the pizzas nice edge.

For the dough i usually use:
½ bag of dried yeast (5 grams)
2dl of warm water
1 teaspoon of salt or little more
5dl of flour (full grain)
2 teaspoon of oregano
3 tablespoon of olive or rapeseed oil.
(be your self and add anything you like in this recie)

Mix the yeast with water, salt and oregano and then pour it into bowl with flours. Give good stril until the dough is even and then let it sit for 20 mins and your dough is ready.

Btw. beer can(un opened) is good rolling pin if you don't have one. :P
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Min. bedgrootte
50 mm (Klein)
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie