Minnie Mouse Keychain

Standard 0.2mm print profile. Place each section with the flat side on the build plate. I enabled and painted supports for the bow, not sure if they were needed but they were easy to remove and ensured a successful print. Once complete just glue the two halves together. Be mindful they line up front to back and side to side (mine is off a tiny bit side to side but not too noticeable). I used a Key Ring outer diameter is 1 inch (25mm), the chain is approx.1.1 inch in length, the open jump ring is 0.4 inch in diameter which I found on Amazon and it appears Maker World also has them for sale.