Minute/Degree guide for leveling bed

The following is a leveling tool that goes hand in hand with Klippers Screw tilt adjust bed leveling feature. This may also work with any other leveling plugin that uses hours and minutes as the unit of measure for rotation. You should already have this set up to probe each screw location before running the calibration. This was originally created for the Sovol SV06 Plus since most of the leveling guides out there only use an M3 screw while the SV06 uses an M4 for its screws. I have gone ahead and added a Degree version of the guide as well as an M3 version of the center lock. I assume it would work the same but have not tested this. Should work with plugins or macros that give degrees as the unit of measure for rotations. If you're using a Bambu or any other printer capable of multi-color then just use the 3MF as it's already color-painted for you. All you have to do is update the file with your colors and it should be good to go. If you are not using a multi-color printer then I sugg