Slicer Discord
Mirror Monocular – 3D-Druckmodell von Thingiverse Thingiverse

Mirror Monocular

von Kalvin
2 Downloads
0 Likes
0 Makes
Zum Modell
Espejo para auto que utilizan como accesorio, los conductores con discapacidad ocular. El espejo es convexo y se instala en el borde del capot acomodandolo hacia el lugar que el conductor quiera.
El espejo lo compre por separado y mide un diametro exterior de 3.072 ", use pegamento para fijarlo y lleva tornillos y tuercas como las figuras muestran.-
Use 2 imanes de neodimio fijado en la base inferior que ayudan a fijarlo en la chapa, ver imagen.-

Car mirror used as an accessory, drivers with ocular disabilities. The mirror is convex and is installed on the edge of the hood adapting it to the place that the driver wants.
The mirror buy it separately and measures an outside diameter of 3.072 ", use glue to fix it and takes screws and nuts as muestran.- figures
Use 2 neodymium magnets fixed to the lower base to help fix it on the sheet, see image.-
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen