Mirrored Ender 5

This is a set of mods I made to move all of the wiring on an Ender 5 to the left side. I have a Makergadgets Innovator Control enclosure, and the wiring access point is on the back left. To get the electronics outside of the enclosure, I had to make these changes to the Ender 5.

**Note that these changes require flashing your firmware.**

First is a support brace for the bed wiring with two points for zip ties. You'll need an M4 x 12mm screw to secure this where the stock M4 x 10mm currently on the back left of the bed carriage.

Second is a rotated Y limit switch. Remove the current Y limit switch plate, put it on the rotated version, and mount on the front left bracket.

The last part is optional: it's a cover for the X stepper belt with zip tie holes built in.

You'll also need to reverse the X gantry. To do so:

1. Have a plan for the control box wiring.
2. Unplug everything.
3. Remove all of your interior Y axis POM wheels (the ones with eccentric nuts). Continue re