MiSTer V2 - Extended Bottom

This is an extended bottom for the MiSTer V2 case by MiSTerAddons.com. I was never too happy with how the "sidecar" attached to the main case and the need for a clunky cable looping down. Luckily the designer of that case is a great person and gave me his blessing to fiddle with the original design files.

This is only a replacement bottom shell and covers. You will need to print a top shell and buttons from the original MiSTer V2 case. https://www.thingiverse.com/thing:3647626

This case is designed to contain the following:
- Official USB Hub v1.2 or v2.1
- Terasic DE10-Nano
- Official IO Board v6.0
- Official SDRAM XS Board

There are two versions attached. The one you print depends on how you connect to your USB Hub. If you use the pin header PCB, print those files with four copies of the M3 washer. In addition to these prints, you will need four 14mm M3 standoffs.

Tolerances are tight. Take your time and don't force anything. Getting the IO board seated prope