Mittens Blocker

This is a Mittens Blocker that's used when knitting mittens. After you are finished with the knitting you wash the mittens and then when they are drying you insert this blocker inside the mittens that will stop the shrinkage at the correct hand size.

There are four files:
- MittensBlocker-FullSize
- MittensBlocker-Part1
- MittensBlocker-Part2
- MittensBlocker-Thumb

But you can choose if you want to print:
**FullSize + Thumb**
or
**Part1 + Part2 + Thumb**

I just had to split the FullSize in two because my print bed was not big enough for the entire thing.

The stl files in 100% scale is a size 8 mitten, which is quite a big mitten.

## Custom scaling
But you can scale the file down to make it fit your hand (or up). One possibility to do this is to measure with a ruler across your hand (and add 1cm to not make it to tight).
Then scale the X and Y axis for all stl files to fit. Like if your hand is 6.9 cm across, you scale the X and Y from 100% (100mm) to 79% (79m