Thingiverse
Mitutoyo Caliper Stand
von McDoodie
1.9k
Downloads
1.4k
Likes
20
Makes
This is a remixed stand for Mitutoyo 500-196-30 calipers. I shamelessly based this design off of labtec901 stand for their iGauging Calipers Stand/Holder after seeing their reddit post.
https://www.thingiverse.com/thing:4804770
No supports needed. Just glue the caliper holder to the stand base. Also can print some small feet in TPU and glue to the bottom for some anti-slip.
https://www.thingiverse.com/thing:4804770
No supports needed. Just glue the caliper holder to the stand base. Also can print some small feet in TPU and glue to the bottom for some anti-slip.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!