Thingiverse
Mitutoyo Digimatic Indicator Case
by AquaticBikes
1
Downloads
5
Likes
0
Makes
A protective case for my Mitutoyo Digimatic Indicator Model ID-C112AE (12.7mm by 0.001mm). It retains the indicator with a snug fit on the indicator body to protect the plunger.
This design uses two 5/8" by 1/8" diameter roll pins for the hinges and a 1" by 1/8" roll pin for the latch. If you don't want to buy roll pins a solid pin will work, you just have to toss a little CA to retain it.
Print the box in your material of choice, I used CF-PETG here but have used regular PETG and PLA without issue for similar cases.
The seal is designed to print in 85A TPE but any flexible filament should work.
A little felt on the inside of the lid upgrades the aesthetics a little. I have vapour phase corrosion inhibitor strip under the felt to protect the indicator for years to come.
This design uses two 5/8" by 1/8" diameter roll pins for the hinges and a 1" by 1/8" roll pin for the latch. If you don't want to buy roll pins a solid pin will work, you just have to toss a little CA to retain it.
Print the box in your material of choice, I used CF-PETG here but have used regular PETG and PLA without issue for similar cases.
The seal is designed to print in 85A TPE but any flexible filament should work.
A little felt on the inside of the lid upgrades the aesthetics a little. I have vapour phase corrosion inhibitor strip under the felt to protect the indicator for years to come.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
