Mixpower 16.5in Case Additional Support

If you weigh these cases down they sag a fair bit in the middle. Came up with this solution to both stiffen the bottom and add support. InstructionsPrint the alignment jigs (left and right) and 3 of the preferred braces. I&#39;ve setup 4 different sizes depending on what size screws you have, recommend a flathead self tapper. Any screws used should only be 6mm long. The bottom of the box is only 2.5mm and the support is 5.6mm.M2.5 ( I used these https://www.mcmaster.com/95893A422/ )M3M4Drill your own with a 1mm pilotDrill out the braces with the appropriate size pilot for the screw you want to use. For me I printed the M2.5 and used a 2mm bit for the screws I had just to clean up the id a little bit.Layout the alignment jig and bars as shown below.One bar at a time, hold the bar down in place and drill through the 3 holes in each bar into the case.Once done with all 9 holes remove everything and it should looks like this.<img src="https://makerworld.bb