Thingiverse
MJX Hyper Go Servo mount conversion 14210
von TurboCinqy
12
Downloads
21
Likes
0
Makes
Mount / bracket to make the 21 gram DSpower servo fit on a 1/14 scale MJX Hyper go.
Servo spline is 6mm on this servo. Have to drill the original out to 5.5mm heat it up and press fit it on the servo.
Be careful with that.
Hole support integrated. Just make a 2.5mm hole through it after printing. It's only one layer.
No support needed for printing.
Servo:
DSPower 21g mini servo metal gear. on AliEx.
Servo spline is 6mm on this servo. Have to drill the original out to 5.5mm heat it up and press fit it on the servo.
Be careful with that.
Hole support integrated. Just make a 2.5mm hole through it after printing. It's only one layer.
No support needed for printing.
Servo:
DSPower 21g mini servo metal gear. on AliEx.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
