MK3S Sheet Wall Holder
von KrohmKoala
40
Downloads
20
Likes
2
Makes
I needed a wall holder narrower because of where i needed it and i wanted a side unclose to allow sliding the sheet in from the side, so here it is :)
I hope you'll enjoy it and if you like it, don't hesitate to throw a tip to support me :D
I hope you'll enjoy it and if you like it, don't hesitate to throw a tip to support me :D
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
