MK4 Mega Pro Snap-On Laser Adapter

This is a snap-on laser adapter for the mega pro. It works by using 4 magnets to align the laser with the print head but since it goes over the fan, it is not meant to be on all the time. This is a quick on/off for the laser.

Additional Hardware:
You will need everything that the MK4 mentions in the install as well as these additional pieces.
- 4 3x8mm magnets
- 5 m4 x 8 bolts

Install:
Install the 4 magnets into the laser cover and the laser adapter, paying close attention to orientation.
Unscrew the original assembly housing that mounts the laser onto the print head.
Unscrew the magnets from the laser
Screw the Laser adapter to the laser using the 5 m4 bolts.
Install the Laser Adaptor cover in place of the cover plate.

When using the laser, align top slot and magnets to mount successfully.