MK52 cable chain bed clamp

got a mk52 style bed for my printer. when I made my new cable leads, I had printed a few of the stock prusa clamps, some custom one, (about 4-5) and none of them cleared my screw terminals & none had a cable chain connection

Designed these in Fusion

tolerances for the nuts is a bit tight, I heat set them in, but you could probably scale it a tiny bit if you dont have a way to heatset them.

I used tree supports in cura ( rest of settings are below)
Tree
support branch angle: 50*
support branch distance: 1mm
support branch diameter: 2mm
support branch diameter angle: 4*
Support collision res: .2mm
Touching build plate

Supports pop right off