MK8 Autolevel Bracket Rev 4

Just made a small adjustment to the design to improve mounting to a Geeetech Prusa i3 Pro B. One screw kept coming out due to the bracket hitting the extruder mount base and only having one thread or so holding on. a simple cut of a corner and now there it just fits better. those of you who mounted on say a pro c will see no difference in mounting. I mainly did this for the pro b setup. i swapped out mine the moment i was done printing it and even made the video. took longer to upload the video then adjusting design in sketch up, re slic3r it, printed it, and mounted it. and even redid my firmware with the new numbers before the video finished uploading. no supports needed, and make sure to insert the magnets quickly after done printing.
https://youtu.be/IcuFkOzr-5k
https://youtu.be/kL-ybOc24Ws