Thingiverse
MK8 i3 rewamped
by SilentN00b
11
Downloads
5
Likes
0
Makes
While not really a remix (more a rebuild) it is based fully on XDr4g0nX's MK8 i3 - 50mm Radial Circular Fan Shroud.
The design is easy to print, makes an easy fit to Geeetech MK8 metal bracket, a 50mm radial fan should slip right on (given output hole being ~ 17.5 x 13 mm), just like XDr4g0nX's version it's just a slip on fit.
It also holds a 12mm wide sensor for bed sensing.
Sensor offset from center of shroud is X = 40 mm and Y = 22.5 mm, but since your hot end might not be exactly in the center just use them as guidelines and measure your parts.
The mount is a very tight fit to make sure it sits still, you might need to widen holes a few microns with a screwdriver or similar.
The design is easy to print, makes an easy fit to Geeetech MK8 metal bracket, a 50mm radial fan should slip right on (given output hole being ~ 17.5 x 13 mm), just like XDr4g0nX's version it's just a slip on fit.
It also holds a 12mm wide sensor for bed sensing.
Sensor offset from center of shroud is X = 40 mm and Y = 22.5 mm, but since your hot end might not be exactly in the center just use them as guidelines and measure your parts.
The mount is a very tight fit to make sure it sits still, you might need to widen holes a few microns with a screwdriver or similar.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
