MKS DLC32 Max Case Base

The Lid Top can be found at https://www.thingiverse.com/thing:5340063

I downloaded and printed the Housing for MKS DLC32 V2.1 by Darwin-de " https://www.thingiverse.com/darwin-de/designs ", but when my controller board arrived, it didn't fit :o( . Because I had ordered the Max version, Doh! So I remixed Darwin-de's version.

Ich möchte Darwin-de danken (Gute Arbeit ;o)

It can be printed without supports, but adding some supports just above the sockets would give a nicer-looking print.
All settings are the same as the original; however, the screw holes are for threaded inserts, only two are needed for the board now, as it does lock into place.
If you don't have threaded inserts, use some Hot glue or something similar in the holes, then add the screws while the hot glue is still hot.
13mm holes for the cable; if you have grommets, they fit nicely. I also have some slots next to the cable holes for tie wraps.

.obj & .glb files have been added.