MKS GenL Case for Ender3

You can remix this in Tinkercad:

TinkerCad Link: https://www.tinkercad.com/things/bCu2YSLCM1U

Supports are needed for the Case on the:

- Letters
- Cable Tunnel
- Front Screw Plate

Lid has little stubs that act both as hinges and as lid latches The longer stubs are the hinge and are meant to be press fit on the left side of the case (side with the USB and ribbon cable hole)

The fan mount was sized to fit a 40x10 mm Noctua fan. This is a press fit mount, no screws required to install the fan.



Print the Lid and Case separately.