MKS + Mosfet Case

MKS and MOSFET case for **Flsun i3**

I wanted to manage my cables a little better, so I crammed everything up in this smiling box.

It might be a little tight installing all the cables, but once done, it's much nicer to look at. I had to run some cables under the boards, they are elevated off the base quite a bit, so it should be ok.

It helps to ziptie the cables right inside the box, and right outside the box, this helps to keep the cables in place, not exerting force to connections inside the box.

2 x 40mm fans are optional, I didn't really need the active cooling since I installed the MOSFET for the hotbed, but I kept it there just for peace of mind. Use **m3 bolts** to fix the boards to the case, then the lid to the case, and you are good to go!

//

*Please take note that the case is designed for the specific model of MKS board Gen L and MOSFET, the holes for the screws may not fit other MOSFETs or control boards.*