MLP - Mane 6 models - remeshed

I remeshed these and sized them up a bit. They've been subdivided twice, and I fixed any errors that resulted. They still sort of have an open spot inside their mouth if you slice with S3D, but i haven't had an issue with it bothering the prints.

I guess the original models came from: kp-shadowsquirrel.deviantart.com/ - so check it out if you get some time.

I would definitely print with supports. I used 25% support infill, with a few dense layers at the top. You can flip the ponies upside down and print with supports and a raft... sometimes it ends up using less support material, and is a little easier to clean up.

Enjoy!!