MMDVM Duplex Hat Pi 3 Snap Case Ethernet Base

All parts other than base are same as original. Remixed to allow for hardwiring/ethernet. Thanks to dlevasseur! Original: https://www.thingiverse.com/thing:6422244

This case fits perfectly using a Pi 3B v1.2 or 3B+, and MMDVM Duplex board v1.47, link below:

https://www.amazon.com/GOOZEEZOO-Hotspot-Display-Support-Raspberry/dp/B0BP69NSR6?th=1

Using Cura: Printed my modified base upside down with 4mm brim, normal support (touching buildplate), support overhang angle 60 (so it only supports inside of base, not outer edges).