Thingiverse
Moai Magnet Doorlock
von aGrav
4
Downloads
0
Likes
0
Makes
Loved the design of this door lock however, I did find that it was not as tight of a press fit as I would like and I did not want to drill and tap my Moai frame, and the part. So I Redesigned it with some press fit tabs on the shank that presses into the Moai frame.
I've included the .sldprt file so that you can modify it to require less force to install.
I also adjusted the magnet slots to fit 5mm diameter, 2mm thick cylinder magnets; That's what I had laying around.
Hope you enjoy!
Cheers!
I've included the .sldprt file so that you can modify it to require less force to install.
I also adjusted the magnet slots to fit 5mm diameter, 2mm thick cylinder magnets; That's what I had laying around.
Hope you enjoy!
Cheers!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
