Slicer Discord
Mobile Charging Dock V2 – 3D printable model from MakerWorld MakerWorld
Organizers

Mobile Charging Dock V2

968 Downloads
252 Likes
589 Makes
Go to Model
This is an update to the older version. I have been using the older version for about a week now and I have experienced some issues. I have tried my best to resolve these issues in this version. I am always open for feedback and suggestions if you have any. Please use the comments section and let me know. Setup Video:https://www.tiktok.com/@usmannaeem23/video/7395301024732302608 Whats new:This version has a support for the phone stand which prevents the phone from falling backwards. Larger phones like iphone 15 ProMax had this issue. It should be resolved now. I would like to have some feedback if someone uses it for a ProMax phone. Cable organization has been improved. Specially at the bottom. It is now possible to easily pull/push the phone chargning cable. It was very hard to swipe from down up on the phone to go to home screen. The screen has clearance now to do the same easily without picking up the phone.The slicer might say that supports might be needed as there is bridging but
Category
Organizers
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection