Thingiverse
Mobilephone stand simple
von Waessman
1
Downloads
3
Likes
0
Makes
80 x 9,4mm area ( around 79.7x9.1 - 79.8x9.2 when its printed.
Holes for speakers are 11mm inset and 15mm wide each.
No support needed, but enable bridge settings. Print as it is
Holes for speakers are 11mm inset and 15mm wide each.
No support needed, but enable bridge settings. Print as it is
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
