Slicer Discord
Mobula 8 - Battery Clip – 3D printable model from MakerWorld MakerWorld
RC

Mobula 8 - Battery Clip

by Lému · RC
154 Downloads
38 Likes
82 Makes
Go to Model
The mobula 8 is a good drone, but its battery attachment system is far too limiting. To increase the choice of drone batteries that can be used with the mobula 8, we need to make a few adaptations. I've designed a very simple and flexible system to allow you to quickly switch from one battery to another. It's also very light, so there's no impact on the drone's flight capacity. I've created 4 models, for 4 batteries that work well with the Mobula 8. The models are identified by dots in the clip: LAVA2S 550 : 1 dot (The battery with the shortest flight time : ≈2 minutes)TATTU2S 450 : 3 dots (The funniest battery for this drone, but a little short on flight time : ≈3 minutes)FLYWOO2S 750 : 2 dots (a good compromise between flight and agility : ≈4 minutes)FLYWOO2S 1000 : 4 dots (This battery keeps the drone in the air the longest, but makes it a little heavy and clumsy : 5 minutes)Note: I'm not affiliated with drone-fpv-racer, and I get nothing if you buy the batte
Category
RC
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

Lému also publishes on

19 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection