Thingiverse
Modcase EVO mATX Side Panel – Multi-Material Mesh Remix
by Gallapagos
0
Downloads
3
Likes
0
Makes
**This is a remix of the side panels from the [Modcase Evolution](https://modcase.com.au/products/evo) case. Very nice baseline design, I highly recommend it!**
I wanted my side panels to have a bit more flare to them, so I made them into multi part pieces! The mesh can be printed in a separate material to the frame, such as PLA for the mesh, and PETG for the panel frame.
**Do not print the frame pieces in PLA! They will warp over time.**
I did this as I wanted a silk bronze filament, and PLA is one of the only materials with a large variety of colors and finishes.
The mesh is glued into the frame with CA glue; be sure to have some clamps around to hold it in place. They have held up fine for the first week of use, should be fine for long term.
I wanted my side panels to have a bit more flare to them, so I made them into multi part pieces! The mesh can be printed in a separate material to the frame, such as PLA for the mesh, and PETG for the panel frame.
**Do not print the frame pieces in PLA! They will warp over time.**
I did this as I wanted a silk bronze filament, and PLA is one of the only materials with a large variety of colors and finishes.
The mesh is glued into the frame with CA glue; be sure to have some clamps around to hold it in place. They have held up fine for the first week of use, should be fine for long term.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
