Model Aircraft Stand

This is a swept stand for a flying model aircraft.

Print settings:
- 1mm to 0.06mm layer height (Depending on printer)
- Full supports are needed
- Set higher bed temperature (If applicable) to avoid edge warping (~60C)

The aircraft designed for this stand was a 1:48 scale Kitty Hawk F-101B but will fit other planes with creativity.

The stand was attached with a hole drilled at the bottom, it is recommended to use hot glue to attach as other polymer cements can take some time to set.

The base of the model has a 60mm x 80mm rectangular indent for a letter size information card.