Thingiverse
Model Building Risers
von Rastl
3
Downloads
4
Likes
2
Makes
This is a set of risers to help with assembling models. The risers go from 1mm to 5mm and can be used in any combination to acquire the necessary height to hold a model off the table while other pieces are glued in place.
1mm and 2mm do not have sockets or pegs since they're too thin for that. 3mm, 4mm, and 5mm have stackers (sockets and top pegs) and toppers (sockets).
They don't snap-fit and can be angled around to hold the model in whatever configuration is needed.
Consider these the cinder blocks of model building. :)
1mm and 2mm do not have sockets or pegs since they're too thin for that. 3mm, 4mm, and 5mm have stackers (sockets and top pegs) and toppers (sockets).
They don't snap-fit and can be angled around to hold the model in whatever configuration is needed.
Consider these the cinder blocks of model building. :)
Rastl veröffentlicht auch auf
5 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
