Thingiverse
Model Defibrillator
door PinballerShotCaller
0
Downloads
3
Likes
0
Makes
A toy defibrillator.
You will need:
x2 5mm diameter springs, about 30mm long. I used a part from (https://www.amazon.com/dp/B0BWHZFTZK?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1)
x1 10mm wide LED. I used (https://www.amazon.com/dp/B01AU6UG70?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1) and cut out the rubber sleeve
Print body bottom side down. Print paddles hole side down. Glue the springs in to the designated holes on two defibrillator pads, and one defibrillator base. The led should stick out slightly from the top. The LED can be programmed to flash by a separate logic controller.
You will need:
x2 5mm diameter springs, about 30mm long. I used a part from (https://www.amazon.com/dp/B0BWHZFTZK?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1)
x1 10mm wide LED. I used (https://www.amazon.com/dp/B01AU6UG70?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1) and cut out the rubber sleeve
Print body bottom side down. Print paddles hole side down. Glue the springs in to the designated holes on two defibrillator pads, and one defibrillator base. The led should stick out slightly from the top. The LED can be programmed to flash by a separate logic controller.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!