Thingiverse
Learning
Model downloaden
Model Rocket Components
187
Downloads
112
Likes
0
Makes
These are model rocket components printed in PLA.
I had a thin wall PVC pipe with a 1 5/8 OD approximately 17 inches long and decided to make a model rocket out of it.
The pipe wall is 1/16 inch thick and 170 grams.
I designed 4 whistles into the nosecone, hoping it will scream on takeoff.
Guides on the fins and shroud are sized for a 3/16 or 1/4 inch guide rod.
The assembled rocket will probably need an E or F engine.
I had a thin wall PVC pipe with a 1 5/8 OD approximately 17 inches long and decided to make a model rocket out of it.
The pipe wall is 1/16 inch thick and 170 grams.
I designed 4 whistles into the nosecone, hoping it will scream on takeoff.
Guides on the fins and shroud are sized for a 3/16 or 1/4 inch guide rod.
The assembled rocket will probably need an E or F engine.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
