Thingiverse

Model Rocket Fin Alignment Jig

von j0z

136 Downloads

64 Likes

1 Makes

This is a fin alignment tool for model rockets. Markings are designed for 3 fin and 4 fin rockets, and fits bt20, bt50, bt60, and bt80 body tube sizes.

STL attached is in mm units already. Each step is approx 0.03 inches less than a perfectly snug fit- adjust up/down based on your printer's tolerances.

Remember to like and post a make!

bt 20 bt 50 bt 60 bt 80 Bt20 bt50 BT60 BT80 fin fins High Power low power mid-power model rocket model rocket fin model rocket fins model rocketry rocket fin rocket fins rocketry

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Model Rocket Fin Alignment Jig

Zur Sammlung hinzufügen