Thingiverse
Modern Coffee Table 3D Printed Brackets
von jake22
75
Downloads
42
Likes
0
Makes
Coffee Table. 1/2" plywood was used. The benefit of this design is it can be stored and folded flat when moving. Needed a tighter fit between the brackets and wood so I printed plastic shims. Still a little wobbly but gets the job done.
Recommendations:
- scale down slightly in order to get a tighter fit with the wood
- if not concerned about move-ability, use wood glue and nail gun to increase strength at corners
Recommendations:
- scale down slightly in order to get a tighter fit with the wood
- if not concerned about move-ability, use wood glue and nail gun to increase strength at corners
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
