Modern Doric Table Lamp #2

Table lamp consisting of two parts. Only one bolt and nut required.Materials needed:150gram matte white pla (i used e-sun)250 gram matte black pla (i used creality hyper-cf black)1 m4 bolt and nut 1 light fitting e27 (https://www.amazon.nl/dp/B093WWWW3F?ref=ppx_yo2ov_dt_b_fed_asin_title)1 bulbPrint instructions (i have ender 3v3 ke):Bottom part (13 hours print)0.12 mm line heightnormal line width settingsinfill for your own prefferencefuzzy skin: create part modifiers in orca slicer to ensure the fuzzy skin is only on the outside surface of the base. This will decreas print time. Make sure to select contour as the fuzzy skin mode.0.2 mm point distance & 0.6 mm skin thicknessmake sure the first cm does not use fuzzy skin!!Top part (7 hours print):vase mode8 bottom layers0.7 mm line widht (i have 0.4 mm nozzle)0.12 mm line heightprint upside downprint max 100mm/sAssembly:Put the light fitting in the base by putting the plug through the hole and pulling the cable through entirely untill t