Modern Fountain

I designed the water pump using a 3v-5v DC motor and a youtube video describing how to print the sections. You can find that video here: https://www.youtube.com/watch?v=D9U0oTbe79U

I also soldered a USB onto the DC motor so it is powered by a USB cord and also connected a tubing to the motor that fed into the hole that feeds the top of the fountain.

I sliced using Cura with supports everywhere which was a little annoying getting all of the supports out but definitely do-able.

Messing with scaling should be ok, just be aware that whatever tubing you are using should slide through the hole that feeds the top of the fountain. I actually recommend scaling the print up a little.

Don't forget to glue the fountain down to the base!