Thingiverse
Modified 3D Printable Jet Engine Stand
door LevelUpper
2
Downloads
3
Likes
0
Makes
The original stand required the use of adhesive between the two cut portions of the stand to a connector piece, and I didn't have super glue lying around so I had to improvise, adapt, overcome.
This remix of the stand requires the use of eight (8) round head M3x6mm machine screw and eight (8) M3 machine screw nut. The stand includes indents for the screw head, and the connector includes indents for the hex nut.
Initially I intended to use the M2.5 screws to reduce the BOM list, but those were longer than the height of the base of the stand...
[EDIT on 2020/07/02] I re-uploaded the STL files because the preview for the files was not working till now.
This remix of the stand requires the use of eight (8) round head M3x6mm machine screw and eight (8) M3 machine screw nut. The stand includes indents for the screw head, and the connector includes indents for the hex nut.
Initially I intended to use the M2.5 screws to reduce the BOM list, but those were longer than the height of the base of the stand...
[EDIT on 2020/07/02] I re-uploaded the STL files because the preview for the files was not working till now.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
