Modified Creality Mask with Powerbot Filter

This mask is the best fitting I found to use. I had several new Samsung PowerBot filters from a broken powerbot vacuum and I created a filter box to hold it and attach to this mask. It forms a tight seal due to the filter's rubber gasket, and the cover is held in place with either rubber bands or the supplied TPU printed straps.

The mask, filterbox, and cover are printed in PLA.
The straps are printed in TPU, then hot-glued to the correct size.

Printer Settings PLA:
1st Layer temp: 210
Other layer temp: 200
Bed Temp: 60
Speed: 80 mm/s
Supports: yes (mask and filter box)

Printer Settings TPU:
1st layer temp: 240
Other layer temp: 225
Bed temp: 60
Speed: 50 mm/s