Thingiverse
(Modified)E3D V6 Volcano Remote Pipe Cooling Blowing System
door dissifilo
11
Downloads
13
Likes
0
Makes
DO NOT use Internal supports, ONLY touching Plate.
Set with M3 screws.
Better with PETG filament printing for avoiding thermal deformation.
Pipe internal diameter 16mm. (I choose silicon pipe with 12V turbo Fan, worth it.)
Layer Height 0.1~0.2mm
It might need washers for advanced adjustment if the printing accuracy wobbles.
Note: Hanger Strength Modified_2020.Jan.2
Note: Blow Pipe Connector Modified_2020.Jan.3
Note: Adding Pipe Route Connector_2020.Jan.4
Set with M3 screws.
Better with PETG filament printing for avoiding thermal deformation.
Pipe internal diameter 16mm. (I choose silicon pipe with 12V turbo Fan, worth it.)
Layer Height 0.1~0.2mm
It might need washers for advanced adjustment if the printing accuracy wobbles.
Note: Hanger Strength Modified_2020.Jan.2
Note: Blow Pipe Connector Modified_2020.Jan.3
Note: Adding Pipe Route Connector_2020.Jan.4
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
